The MyHopper KMH4C is computer switches that allow access to two IBM compatible computers respectively from one PS/2 keyboard, mouse and monitor. Switching between computers is as easy as pressing the push button or entering hot-key commands from your keyboard. There is no interface card and software to install and the MyHopper is independent of the computer operating system.
Ready to run right out of the box, this Kit comes with everything you need - a switch and complete cable sets, just hook them up and go. By allowing one console to manage all your computers, the MyHopper eliminates the expense for extra consoles, the spaces for extra peripherals and the time hopping around for accessing different computers.
Console Connection
Turn your computers off. Connect a PS/2 keyboard to the mini-DIN-6 port marked with “Keyboard” and a PS/2 mouse to the mini-DIN-6 port marked with “Mouse”. Then connect your VGA monitor cable directly to the HD-DB-15 port as shown below for 4-port MyHopper.The multi-sync monitor must be capable of synchronizing with the computer's video signal. If you are uncertain about the monitor type, please consult the monitor user's manual.
The MyHopper consumes negligible power and is designed to run reliably without an external power adapter.
Computers Connection
MyHopper comes with complete cable sets facilitating computer connection. One side of the cable has an HDB-15 connector and the other side has three connectors (one HDB-15 and two mini-DIN6s). The PC1 ~ PC4 marks on the MyHopper are for computer connection as shown below.NOTE : If your computer uses an AT style keyboard, you will need an "AT-to-PS/2 keyboard adapter" at the computer keyboard port.
Features
Unique loose-free cables included preventing keyboard or mouse connector from getting loose
Supports PS/2 keyboard and mouse
Keyboard and mouse emulation for error-free PC boot up
Keyboard and mouse are hot pluggable at any time without turning either MyHopper or PCs off
Space-saving design - all cables are connected to the rear
Auto scan automatically selects computers sequentially
Supports M/S IntelliMouse (Pro), Explorer, Optical
Hot-key and push button allow easy computer access
Keyboard states automatically saved and restored when switching computers
Operating system independent, transparent to all applications
High VGA resolution 1920x1440
DDC2B compatible
Power-free operation - the MyHopper draws power from the attached PCs
Specification
KMH4C
Console port number
1
Computer portnumber
4
Audio support
No
Port selection push button
Hot plug-and-play
Yes
Hot-key control
VGA
1920 x 1440, DDC2B
Computer connector
HDB15 x 4
Console connectorKeyboardMouseMonitorSpeaker/Mic
PS/2PS/2HDB15
Automatic scan interval
3, 8, 15, 30 seconds
KVM Cable set
1.8m x 4
Audio Cable set
H x W x D (mm)
20 x 85 x 180
Power-free operation
